Ciao a tutti ,
sono nuovo del mondo WRT e come tale ho i primi problemi.
Appena mi ? arrivata sono riuscito ad installare il tutto con AP51 flashando tranquillamente la fonera con DD-WRT.
Dato che poi da quello che ho potuto leggere nei forum ho visto che openWrt ? nettamente pi? stabile
vorrei passare a questo.
Di conseguenza leggendo sempre questo post ho trovato la seguente guida
Installato X-wrt su fonera 2200 con AP51 smiley
impiegato meno di 20 minuti.
questo ? il file caricato in rootfs:
http://downloads.x-wrt.org/xwrt/kamikaze/7.09/atheros-2.6/openwrt-atheros-2.6-root.jffs2-64k
e questo in kernel:
http://downloads.x-wrt.org/xwrt/kamikaze/7.09/atheros-2.6/openwrt-atheros-2.6-vmlinux.gz
non spuntare le opzioni create nvram ecc.
selezionare la scheda di rete
cliccare su GO
quando compare la scritta: no packet
dare alimentazione alla fonera
5/10 minuti , ap51 termina la sessione e si chiude automaticamente.
attendere ulteriori 10 minuti e poi dal browser al 192.168.1.1 si trova il sospirato kamikaze.L'ho applicata alla lettera ha finito il tutto ma quando si riavvia sembra funzionare ma effettivamente non va.
Premetto che ho una fonera 2201 e che con ddwrt tutto ok.
Mentre con openWRT appunto niente.
Dopo di che ho attacca alla seriale per vedere che messaggi mi dava e quindi di conseguenza li posto qui.
In cosa posso aver sbagliato?...c'? un altra procedura da seguire?
Grazie a tutti.
+Ethernet eth0: MAC address 00:18:84:a4:89:7c
IP: 192.168.1.206/255.255.255.0, Gateway: 192.168.1.100
Default server: 192.168.1.166
RedBoot(tm) bootstrap and debug environment [ROMRAM]
OpenWrt certified release, version 1.1 - built 22:32:28, May 7 2007
Copyright (C) 2000, 2001, 2002, 2003, 2004 Red Hat, Inc.
Board: FON 2201
RAM: 0x80000000-0x81000000, [0x80040290-0x80fe1000] available
FLASH: 0xa8000000 - 0xa87f0000, 128 blocks of 0x00010000 bytes each.
== Executing boot script in 10.000 seconds - enter ^C to abort
RedBoot> fis load -d vmlinux.bin.l7
Image loaded from 0x80041000-0x80290085
RedBoot> exec
Now booting linux kernel:
Base address 0x80030000 Entry 0x80041000
Cmdline :
Linux version 2.6.21.5 (travis@localhost.localdomain) (gcc version 4.1.2) #125 T
ue Jun 3 00:02:24 CDT 2008
CPU revision is: 00019064
Determined physical RAM map:
memory: 01000000 @ 00000000 (usable)
Initrd not found or empty - disabling initrd
Built 1 zonelists. Total pages: 4064
Kernel command line: console=ttyS0,9600 rootfstype=squashfs,jffs2 init=/etc/prei
nit
Primary instruction cache 16kB, physically tagged, 4-way, linesize 16 bytes.
Primary data cache 16kB, 4-way, linesize 16 bytes.
Synthesized TLB refill handler (20 instructions).
Synthesized TLB load handler fastpath (32 instructions).
Synthesized TLB store handler fastpath (32 instructions).
Synthesized TLB modify handler fastpath (31 instructions).
PID hash table entries: 64 (order: 6, 256 bytes)
Using 92.000 MHz high precision timer.
Dentry cache hash table entries: 2048 (order: 1, 8192 bytes)
Inode-cache hash table entries: 1024 (order: 0, 4096 bytes)
Memory: 13504k/16384k available (1955k kernel code, 2880k reserved, 292k data, 1
16k init, 0k highmem)
Mount-cache hash table entries: 512
NET: Registered protocol family 16
Radio config found at offset 0xf8(0x1f8)
Time: MIPS clocksource has been installed.
NET: Registered protocol family 2
IP route cache hash table entries: 1024 (order: 0, 4096 bytes)
TCP established hash table entries: 512 (order: 0, 4096 bytes)
TCP bind hash table entries: 512 (order: -1, 2048 bytes)
TCP: Hash tables configured (established 512 bind 512)
TCP reno registered
squashfs: version 3.0 (2006/03/15) Phillip Lougher
Registering mini_fo version $Id$
JFFS2 version 2.2. (NAND) (C) 2001-2006 Red Hat, Inc.
io scheduler noop registered
io scheduler deadline registered (default)
Serial: 8250/16550 driver $Revision: 1.90 $ 1 ports, IRQ sharing disabled
serial8250: ttyS0 at MMIO 0xb1100003 (irq = 37) is a 16550A
eth0: Dropping NETIF_F_SG since no checksum feature.
eth0: Atheros AR231x: 00:18:84:a4:89:7c, irq 4
cmdlinepart partition parsing not available
Searching for RedBoot partition table in spiflash at offset 0x7d0000
Searching for RedBoot partition table in spiflash at offset 0x7e0000
5 RedBoot partitions found on MTD device spiflash
Creating 5 MTD partitions on "spiflash":
0x00000000-0x00030000 : "RedBoot"
0x00030000-0x006e0000 : "rootfs"
0x006e0000-0x007e0000 : "vmlinux.bin.l7"
0x007e0000-0x007ef000 : "FIS directory"
0x007ef000-0x007f0000 : "RedBoot config"
nf_conntrack version 0.5.0 (128 buckets, 1024 max)
ip_tables: (C) 2000-2006 Netfilter Core Team
TCP vegas registered
NET: Registered protocol family 1
NET: Registered protocol family 17
802.1Q VLAN Support v1.8 Ben Greear <greearb@candelatech.com>
All bugs added by David S. Miller <davem@redhat.com>
eth0: Configuring MAC for full duplex
VFS: Mounted root (jffs2 filesystem) readonly.
Freeing unused kernel memory: 116k freed
Warning: unable to open an initial console.
Algorithmics/MIPS FPU Emulator v1.5
- preinit -
- init -
init started: BusyBox v1.4.2 (2008-01-08 11:35:21 CST) multi-call binary
Please press Enter to activate this console. device eth0 entered promiscuous mod
e
br-lan: port 1(eth0) entering learning state
br-lan: topology change detected, propagating
br-lan: port 1(eth0) entering forwarding state
PPP generic driver version 2.4.2
wlan: 0.8.4.2 (svn r2568)
ath_hal: module license 'Proprietary' taints kernel.
ath_hal: 0.9.30.13 (AR5212, AR5312, RF2316, TX_DESC_SWAP)
ath_rate_minstrel: Minstrel automatic rate control algorithm 1.2 (svn r2568)
ath_rate_minstrel: look around rate set to 10%
ath_rate_minstrel: EWMA rolloff level set to 75%
ath_rate_minstrel: max segment size in the mrr set to 6000 us
wlan: mac acl policy registered
ath_ahb: 0.9.4.5 (svn r2568)
ath_pci: switching rfkill capability off
ath_pci: switching per-packet transmit power control off
wifi0: 11b rates: 1Mbps 2Mbps 5.5Mbps 11Mbps
wifi0: 11g rates: 1Mbps 2Mbps 5.5Mbps 11Mbps 6Mbps 9Mbps 12Mbps 18Mbps 24Mbps 36
Mbps 48Mbps 54Mbps
wifi0: H/W encryption support: WEP AES AES_CCM TKIP
wifi0: mac 11.0 phy 4.8 radio 7.0
wifi0: Use hw queue 1 for WME_AC_BE traffic
wifi0: Use hw queue 0 for WME_AC_BK traffic
wifi0: Use hw queue 2 for WME_AC_VI traffic
wifi0: Use hw queue 3 for WME_AC_VO traffic
wifi0: Use hw queue 8 for CAB traffic
wifi0: Use hw queue 9 for beacons
wifi0: Atheros 2315 WiSoC: mem=0xb0000000, irq=3