Ti posto i file cosi almeno parliamo di cose concrete
-------------------------------------
Wpa_supplicant
-------------------------------------
ctrl_interface=/var/run/wpa_supplicant
ctrl_interface_group=0
ap_scan=1
# Obviously, different networks will require different options. The wpa_supplic
# This is what most Radius authentication (corporate, school, etc) networks look
network={
ssid="wifi-uni-wpa"
key_mgmt=WPA-EAP
eap=PEAP
identity="email@email.it"
password="password"
phase1="peaplabel=0"
phase2="auth=MSCHAPV2"
priority=10
}
-------------------------------------
-------------------------------------
Wireless
-------------------------------------
config wifi-device wl0
option type broadcom
option channel 13
# REMOVE THIS LINE TO ENABLE WIFI:
#option disabled 1
config wifi-iface
option device wl0
option network wan
option mode sta
option ssid wifi-uni-wpa
config wifi-iface
option device wl0
option network lan
option mode ap
option ssid MiaReteInternaWIFI
option encryption psk2
option key MiaPass
-------------------------------------
-------------------------------------
Network
-------------------------------------
#### VLAN configuration
config switch eth0
option enable 1
config switch_vlan eth0_0
option device "eth0"
option vlan 0
option ports "0 1 2 3 5"
config switch_vlan eth0_1
option device "eth0"
option vlan 1
option ports "4 5"
#### Loopback configuration
config interface loopback
option ifname "lo"
option proto static
option ipaddr 127.0.0.1
option netmask 255.0.0.0
#### LAN configuration
config interface lan
option type bridge
option ifname "eth0.0"
option proto static
option ipaddr 192.168.1.1
option netmask 255.255.255.0
#### WAN configuration
config interface wan
#option ifname "eth0.1"
option proto dhcp
-------------------------------------
Visualizza post
